Issue 1, 2002

Ultrasonic extraction of iron from non-aqueous liquids

Abstract

A novel procedure for the extraction of iron from predominately organic solvents has been described. An ultrasonic probe was used to create a microemulsion with a small quantity of nitric acid such that labile iron could be released into the aqueous vesicles and subsequently quantified after phase separation. The analytical and operational viability of using a simple colorimetric assay based on the coordination of aminothiol ligands (principally homocysteine) was evaluated in terms of signal sensitivity, selectivity and stability. The use of homocysteine provided a linear range for iron(III) from 9 μM to 50 μM with a corresponding limit of detection of 2 μM (based on 3sb). The effectiveness of the approach was assessed through the recovery of 0.3 ppm iron from a sample of commercial kerosene and the results compared with those obtained through attempting to quantify the iron under passive (ultrasonically silent) conditions.

Article information

Article type
Communication
Submitted
29 Oct 2001
Accepted
15 Nov 2001
First published
04 Dec 2001

Analyst, 2002,127, 8-10

Ultrasonic extraction of iron from non-aqueous liquids

A. J. Wain, N. S. Lawrence, J. Davis and R. G. Compton, Analyst, 2002, 127, 8 DOI: 10.1039/B109852G

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements