Putting the power in power-dressing


The fabric is composed of two separate conducting, silver-coated polyamide textile faces joined together by a PVDF spacer yarn

Scientists in the UK developing wearable electronics have knitted a flexible fabric that delivers twice the power output of current energy harvesting textiles.

There is considerable interest and research into wearable piezoelectric energy harvesters that use waste energy from human movement or the ambient environment to power low-energy consuming wearable devices, such as wireless sensors and consumer electronics. Typically these materials are ceramic-based with limited flexibility, so aren’t that comfortable to wear, and include toxic elements like lead. They also involve charge-collecting metallic electrodes with poor fatigue resistance that fail after repeated use. New, less rigid materials with sufficient mechanical strength and an all-in-one design are therefore highly sought after.

The polymeric piezoelectric fibres created by Navneet Soin at the University of Bolton and colleagues in the laboratory of Elias Siores fulfill all of the above: they are flexible, strong and breathable.

The fibres can be knitted together to from a 3D fabric composed of two separate conducting, silver-coated polyamide textile faces (the electrodes) joined together by a poly(vinylidene fluoride) (PVDF) spacer yarn (the piezoelectric component). Compression of the fabric causes the spacer yarn to generate a charge that is collected by the two metallic faces. The melt spinning process used to generate the fibres is much faster than traditional electrospinning and a higher throughput can therefore be achieved.

Seungbum Hong, a nanoscience expert at Argonne National Laboratory in the US, anticipates the design of wearable electronic systems embedded with these piezoelectric energy harvesters in the near future. He identifies that a challenge remains to fully characterise the lifetime of the harvesters at various temperatures in an accelerated way and says that ‘the stability of the device when immersed in water will need to be addressed to implement the harvesters into wearable products.’

Currently 1–5μW/cm2 of power can be generated, enough to power a small sensor. However, the team is confident that optimisation will help enhance the power output. They see scope for applications including sensors for assisted living, non-invasive health monitoring and charging of portable electronic devices.

References

This paper is free to access until 24th March 2014. Download it here:

N Soin et al, Energy Enivon. Sci., 2014, DOI: 101.1039/c3ee43987a


Related Content

The future of fashion

16 October 2012 Research

news image

A hybrid energy harvesting device to power up mobile devices can be integrated into clothing

Flexible solar cell woven into fabric

2 September 2014 Research

news image

Solar cell textiles could one day power wearable electronics

Most Read

UC Davis chemist sentenced to four years over explosion

19 November 2014 News and Analysis

news image

Postdoc sentenced over attempt to make explosive device and reckless disposal of hazardous waste

Spanish fly

10 October 2013 Podcast | Compounds

news image

Helen Scales looks at cantharidin, the active ingredient in this famous aphrodisiac

Most Commented

Beetle behind breath test for bank notes

17 November 2014 Research

news image

Photonic crystal inks inspired by longhorn beetle could help to fight counterfeiting

Nanostripe controversy in new twist

24 November 2014 Research

news image

Creator of striped nanoparticles insists questions over structures have already been answered and accuses critics of a 'perso...