Novel mass sensor is off the scale
04 April 2012
Spanish scientists have produced the world's most sensitive set of scales that should be capable of weighing a single proton. These scales could be used to detect and identify single molecules and atoms, or study in unprecedented detail the binding of atoms to surfaces.
The yoctogram sensor should be capable of detecting a single proton
Several research groups have developed nanomechanical sensors based on this mechanism, using either carbon nanotubes or nanoscale strips of materials such as silicon carbide. But these sensors have generally not been sensitive enough to detect individual molecules and atoms.
To enhance the sensitivity, the group, led by Adrian Bachtold at the Catalan Institute of Nanotechnology in Barcelona, suspended their carbon nanotube over a very narrow trench, just 150nm wide, because short suspended nanotubes produce greater changes in resonant frequency than long ones. They also conducted the measurements in an ultra-high vacuum and at just 4K, reducing any interference from unwanted molecules and electrical noise. But this still wasn't enough.
The problem now was that the resonance frequency of the nanotube began to fluctuate between different levels. These fluctuations were very small, which explains why they hadn't been noticed before.
'We tried to understand the origin of the multiple-level fluctuations,' Bachtold tells Chemistry World. 'One scenario was that the multiple-level fluctuations are caused by contaminating molecules moving on the nanotube surface between different sites. To check this scenario, we annealed the nanotube to remove the contamination and the multiple-level fluctuations disappeared.'
After controlled heating with an electrical current, Bachtold and his team found that their sensor could detect single naphthalene molecules (C10H8) and small numbers of xenon atoms, neither of which had been achieved before. Based on these results, Bachtold calculated that the sensor has a resolution of 1.7 yoctograms (1.7 x 10-24g), around the mass of a single proton.
Still, the sensor can't yet accurately measure the masses of individual atoms and molecules. This is because the reduction in resonant frequency is also influenced by exactly where the particles land on the nanotube and that can't be controlled at the moment, although Bachtold is working on this.
'The paper is very nice and shows that an exceedingly simple mechanical system can be pushed into the hydrogen atom mass limits,' says Alex Zettl at the University of California, Berkeley, who has developed similar carbon nanotube-based mass sensors.
Interesting? Spread the word using the 'tools' menu on the left.
J Chaste et al, Nat. Nanotechnol., 2012, DOI: 10.1038/nnano.2012.42
Also of interest
10 November 2008
Glut of nanotube devices holds promise for ultra-sensitive mass detection
25 April 2007
Sensor that detects mass of particles in a liquid to within one thousandth of a millionth of a millionth of a gram
Comment on this story at the Chemistry World blog
Read other posts and join in the discussion
External links will open in a new browser window