Issue 7, 2010

Using EPR to follow reversible dihydrogen addition to paramagnetic clusters of high hydride count: [Rh6(PCy3)6H12]+ and [Rh6(PCy3)6H14]+

Abstract

A combined structural/EPR/computational chemistry investigation is reported on the two paramagnetic hydrido-cluster salts [Rh6(PCy3)6H12][BArF4] and [Rh6(PCy3)6H14][BArF4], the latter being formed by reversible addition of H2 to the former, [BArF4] = [B{C6H3(CF3)2}4]. The solid-state structure of [Rh6(PCy3)6H14][BArF4] shows an expanded cluster core compared to previously reported [Rh6(PCy3)6H12][BArF4] indicative of the addition of hydrogen to the cluster surface. This expansion correlates well with the calculated (PH3 replaces PCy3) structures. EPR measurements on [Rh6(PCy3)6H12][BArF4] indicate two isomers at low temperature, which are tentatively assigned as diastereomers that result from locked phosphine rotation and bridging hydride/semi bridging hydride tautomerism. The EPR signal disappears above 60 K which is suggested to occur due to fast Raman-type relaxation—a phenomenon consistent with the calculated small SOMO/SOMO − 1 and SOMO/LUMO gaps. For [Rh6(PCy3)6H14][BArF4] EPR measurements indicate two isomers, the proportion of which change with temperature and deuteration—one axial isomer and one rhombic isomer. DFT calculations on a number of plausible isomers give EPR parameters which fit the experimentally determined rhombic isomer to one in which there is an interstitial hydride in the cluster and thirteen hydride ligands on the surface, while the axial isomer has two dihydrogen-like ligands on the cluster surface. That these isomers lie close in energy comes from both the EPR measurements (as measured from equilibrium constants over a variable temperature range) and DFT calculations. Deuteration of the hydrides should favour the isomer with the lowest zero-point energy and this is the case, with the axial isomer (two D2 ligands on the surface) being favoured over the rhombic.

Graphical abstract: Using EPR to follow reversible dihydrogen addition to paramagnetic clusters of high hydride count: [Rh6(PCy3)6H12]+ and [Rh6(PCy3)6H14]+

Supplementary files

Article information

Article type
Paper
Submitted
15 Sep 2009
Accepted
25 Nov 2009
First published
18 Dec 2009

Dalton Trans., 2010,39, 1726-1733

Using EPR to follow reversible dihydrogen addition to paramagnetic clusters of high hydride count: [Rh6(PCy3)6H12]+ and [Rh6(PCy3)6H14]+

R. M. Hiney, A. B. Chaplin, J. Harmer, J. C. Green and A. S. Weller, Dalton Trans., 2010, 39, 1726 DOI: 10.1039/B919209C

To request permission to reproduce material from this article, please go to the Copyright Clearance Center request page.

If you are an author contributing to an RSC publication, you do not need to request permission provided correct acknowledgement is given.

If you are the author of this article, you do not need to request permission to reproduce figures and diagrams provided correct acknowledgement is given. If you want to reproduce the whole article in a third-party publication (excluding your thesis/dissertation for which permission is not required) please go to the Copyright Clearance Center request page.

Read more about how to correctly acknowledge RSC content.

Social activity

Spotlight

Advertisements