Estimating the concentration of bleach
Class practical or demonstration
is added to measured samples of household hydrogen peroxide and the volume of oxygen produced is collected and measured. This is used to compare the bleach content of different bleaches, and also to calculate the concentration of chlorine (sodium hypochlorite) in the bleaches. sodium chlorate(I)
This experiment can be done as a demonstration or, with suitable students, as a class practical. Younger students can compare the
relative concentration or ‘ value’ of different bleaches. Intermediate students could determine concentration and revise redox reactions and half-equations. Advanced students could make use of oxidation numbers to balance equations, consider electrode potentials for the reactions, and also meet hydrogen peroxide behaving as a reducing agent.
A few commercial bleaches in their containers, with prices, can be placed on a suitable tray, each with a 10 cm
3 syringe and 250 cm 3 beaker, both labelled, into which small samples of the bleach can be placed. Students can measure 5 cm 3 of each bleach into their side-arm flask for each experiment. Small samples of the hydrogen peroxide solution could be collected in a 100 cm 3 beaker.
Students should have no access to acid solutions. Bleaches liberate toxic chlorine gas on contact with acids.
Depending on the apparatus used and the number of bleaches investigated, the practical could be completed in 15 to 45 minutes.
Each group of students will need:
Conical side-arm flask (250 cm
Bung, with single hole to fit 10 cm
3 syringe nozzle
Plastic syringe, to deliver 10 cm
3 (Note 1)
Plastic syringe, to deliver 5 cm
3 (Note 2)
Delivery tube (see diagram)
Rubber tubing, short length
Water trough or washing-up bowl
Measuring cylinder (100 cm
Measuring cylinder (25 cm
Beaker (100 cm
Clamp and stand, 2
Deionised or distilled water (25 cm
Access to the following solutions:
A variety of household bleach solutions (IRRITANT)
Hydrogen peroxide, ‘20 volume’ solution (IRRITANT at this concentration), 10 cm
3 per bleach solution
Refer to Health & Safety and Technical notes section below for additional information.
Health & Safety and Technical notes
Read our standard health & safety guidance
Wear eye protection throughout.
Household bleach solutions (containing sodium chlorate(I) / sodium hypochlorite) (unlikely to be CORROSIVE but may be IRRITANT) - see CLEAPSS
Hazcard. Commercial household bleaches usually contain about 5% sodium chlorate(I). Some bleaches also contain detergents and thickening agents, which may cause excessive frothing in this experiment. Note that nowadays some commercially available bleaches do not contain any chlorine and are based on peroxy-compounds. They should not be used here.
Hydrogen peroxide solution, H
2O 2 (aq), (IRRITANT at concentration used) - see CLEAPSS and CLEAPSS Hazcard Recipe Book.
Plastic syringes are used to measure and deliver a known volume of hydrogen peroxide solution, and their nozzles should fit tightly into the hole in the flask bung. 1
Plastic syringes can be used to measure 5 cm 2
3 of bleach solution, but volumetric pipettes with safety fillers could be used instead.
Splashes of bleach and hydrogen peroxide should be washed off immediately with plenty of water.
Use a plastic syringe to measure out 5 cm a
3 of the first bleach into the flask. If a ‘thick’ bleach is used, add approximately 25 cm 3 deionised water. Swirl to ensure complete mixing.
Discuss the fact that this dilution does not change the amount of bleach put into the flask, but does enable proper mixing to take place and ensure the reaction has goes to completion. b
Half fill the trough with water. Submerge the 100 cm c
3 measuring cylinder and fill it with water, invert under water and clamp it in position.
Attach the delivery tube to the side arm flask and arrange the rest of the apparatus as shown in the diagram below. d
Measure 10 cm e
3 hydrogen peroxide solution into a clean plastic syringe, attach it to the bung and gently empty the contents into the flask. Leave the syringe in place.
Carefully swirl the contents of the conical flask and collect the gas liberated. f
Continue until no further reaction is seen. Measure and record the final volume. g
Carefully disconnect the delivery tube from the flask. h
Discard the solution into the sink. Flush away with plenty of water. Rinse the flask thoroughly. Ensure any splashes of bleach are washed off skin immediately and swabbed off benches. i
If time allows, repeat the experiment with the same bleach to obtain three results and take an average. j
Repeat the experiment with different bleaches. k
Here hydrogen peroxide behaves as reducing agent with another more powerful oxidising agent. (More advanced students may expect it to behave as an oxidising agent.)
2O 2 → O 2 + 2H + + 2e -
Chlorate(I) ions are an oxidising agent.
- + 2e - → O 2- + Cl -
Overall equation showing the change of oxidation state of chlorine:
2O 2(aq) + NaOCl(aq) → H 2O(l) + NaCl(aq) + O 2(g)
The maximum volume of gas recorded in the measuring cylinder should have 10 cm
3 deducted from it to compensate for the injection of 10 cm 3 hydrogen peroxide solution into the flask.
Direct comparison of volume of oxygen collected in the measuring cylinder compares the effectiveness of the bleaches for younger students.
’Value’ can be compared by dividing the volume of oxygen liberated by the cost of 5 cm
3 of bleach. This extra step is well within the grasp of most introductory students
Calculation of concentration (in g NaOCl per dm
3) for more advanced students:
(V-10) cm I
3 is the volume of oxygen liberated
(V-10)/24000 is the number of moles of oxygen gas II
(V-10)/24000 is the number of moles of NaOCl in 5 cm III
3 bleach (see equations)
(V-10)/24000 x 1000/5 is the number of moles of bleach in a 1 dm IV
3 bottle of bleach
((V-10)/24000 x 1000/5) x 74.5 is the mass of NaOCl in 1 dm V
3 of bleach solution.
Health & Safety checked, 2016
This Practical Chemistry resource was developed by the Nuffield Foundation and the Royal Society of Chemistry.
© Nuffield Foundation and the Royal Society of Chemistry
Page last updated October 2015