The density of ice
cubes are floated on cooking oil, and students observe what happens to the liquid Ice
produced as the ice water , and the melts changes. Several associated density phenomena may be observed as part of the demonstration. surface tension
Although a very safe and simple experiment, this is more likely to be done as a quick teacher demonstration with class discussion, than as a class experiment. Ten minutes should be ample to make the observations, although discussion of these may be as long or as brief as the teacher decides.
Measuring cylinder (1 dm
3) (Note 1)
Flexi-cam, webcam or similar to display magnified image of events on suitable screen, if available
Water, 400 cm
Cooking oil, 400 cm
3, e.g. pure vegetable oil
Refer to Health & Safety and Technical notes section below for additional information.
Health & Safety and Technical notes
Read our standard health & safety guidance
1 A glass measuring cylinder is preferable to a plastic one, to give clear visibility of events.
2 The ice cubes should be made from water coloured with a blue food dye to ensure visibility for the class, and well frozen to ensure no liquid water remains trapped inside the cubes. Check that the ice cubes actually float on the oil you intent to use.
a Place about 400 cm 3 of water and 400 cm 3 of cooking oil in the measuring cylinder. Allow the two layers to separate fully; the oil will be on the top.
b Drop an ice cube into the cylinder. It will float (just) on top of the oil.
c Observe the cube. As it melts, the water that is formed makes a droplet attached to the cube. Eventually this detaches itself from the cube and sinks, joining the water layer below. This illustrates the anomalously greater density of water compared to ice.
Water that has been dyed blue is easily seen in the pale yellow oil against a white background.
A number of other interesting observations can be made, mostly associated with the high surface tension of water:
After most of the cube has melted, the weight of the water drop is sufficient to drag the remainder of the ice cube down with it; i.e. the average density of the cube and drop is greater than that of the oil. Sometimes, as the cube and drop are sinking, the drop detaches itself from the cube and the cube floats back to the surface.
Small mini-droplets occasionally break off from the main one as it descends forming a ‘string of pearls’ effect.
Water droplets may sit for some time on the water-oil interface without coalescing with the body of the water.
There are interesting changes of shape in the water droplet as it forms, detaches from the cube, and as it sinks.
When the coloured water droplets begin to coalesce with the water, the coloured water can be seen to sink as it mixes, because of its greater density.
The demonstration may need to be repeated with an uncoloured ice cube to show that the same density changes occur.
The density of ice is about 0.92 g cm
-3 and that of water is about 1.00 g cm -3 at 0 °C. Cooking oil has a density between these two and therefore ice floats on the oil whereas water sinks. Most solids are denser than their liquids. The lower density of ice is caused by its open lattice structure, a hydrogen-bonded, tetrahedral network similar to that of diamond:
The structure of liquid water has water molecules more closely packed than this below 4 °C, leading to a higher density.
Health & Safety checked, August 2016
This demonstration is based on an idea developed by Colin Johnson at Techniquest, Cardiff.
This Practical Chemistry resource was developed by the Nuffield Foundation and the Royal Society of Chemistry.
© Nuffield Foundation and the Royal Society of Chemistry
Page last updated October 2015